|
AUTOCLAVE – PROGRAMMABLE (FRONT LOADING)
-
Micro Computerised
control with LCD screen for messages and
With Unique
-
Power failure memory
: auto re-starts process on power resumption.
User friendly:
-
single key press
starts & completes process on its own
-
supervision not
required
-
displays process over
message on completion
-
blinking light for
user attention on message on screen
-
help messages on
screen
-
Protection from
tampering of set parameters: Password incorporated
-
User programmable :
Temp: 121 to 135 deg. C, Time: 15 to 59 mins
-
Safety valve.
-
Front Loading type
construction for ease of operation
-
Robust construction:
stainless steel claving chamber with M. S. Powder Coated Control
body.
-
Safety: process power
configured in cut-off mode in its steady state of rest
-
Self Diagnostic
Software identifies process faults and displays on screen e.g.:
Sensor error, Heating not progressing etc
-
Versatility: permits
stop & edit at any time during process run
-
Provision to Run Wet,
or Wet and Dry Both Cycles
|
 |
|
SPECIFICATIONS |
|
Power Rating – Heater |
2000 Watts |
|
Control System |
Less than 50 Watts |
|
Water Filling |
Manual |
|
Operating Voltage |
230 Volts +/- 10%, 50 Hz, 1Phase |
|
Control Type |
Micro-Computerised control with LCD display |
|
Protection |
Password Protection against un-authorized tampering |
|
Memory |
Stores the process condition at power failure and continues on Power
resumption |
|
Alerts Indication |
By Blinking Light |
|
Wet Temp Set Range |
121 to 135 Degree Centigrade |
|
Dry Temp Value |
Fixed |
|
Set Time Range |
15 to 59 Minutes |
|
Display |
2 x 16 Liquid Crystal Display (2 Rows x 16 Charatcers) |
|
Indication on Display |
- Set/Actual Temp in Deg. Centigrade
- Set Time in MM
- Process Alerts
- Process Over
|
|
|
|
POWER FAILURE MEMORY – HOW IT WORKS?
Once the “Run” key is pressed, the process starts and micro-controller
continuously monitors the process parameters and saves them in internal
memory. At Power Failure these process parameters are stored in Memory
provided on board. This memory is non-volatile and can be retained for a
long period.
On resumption of power, the controller restarts and retrieves the
temperature value at power failure and compares it with actual value on
power resumption. If the drop in temperature is more than 10% of the
value at power failure, then the processor re-starts the process from
beginning and if f the drop in temperature is less than 10% of the
stored value, then the process resumes from where it stopped at power
failure.
This is done automatically.
WHY PASSWORD?
Password is required only to edit process parameters like set
temperature time. Password is not required to Run the Process with
previously set values.
This facilitates the control of Supervisor or H.O.D over process
parameters set values and permits the Junior staff / student to run the
process without need of presence to Supervisor / H. O. D.
WHAT IF PASSWORD FORGOTTEN?
If the user has forgotten Password, then the default Password can be
loaded through Key Switch on the right face of the control panel.
DESIGN & SPECS SUBJECT TO CHANGE WITHOUT NOTICE
|
