|
PRODUCTS>Acryliser 
Large: for 16 flasks. Small: for 8 flasks
FEATURES Micro computerized control with Large LCD screen for messages & values and
With Unique
Power failure memory:: auto re-starts process on power resumption
Versatility:
permits
stop & edit
at any time during process
on
User
friendly:
single key press starts & completes process on its own *
supervision not
required
* displays “process over“ message on completion *
blinking light
draws user attention for message on
screen * flashes
help messages on
screen
to
guide user
User
programmable time - temp cycle.
Protection from tampering of set parameters:
Password
incorporated
Self
diagnostics software: displays
fault condition
on screen making repairs easy.
Robust
unit:
fully stainless steel
body.
Safety: power configured in
cut-off
mode in its natural steady state of rest
Specifications:
Construction
Stainless Steel
Sizes
18X18X18” – LARGE
16x12x12” – SMALL
Water
Filling Manual
Power Rating – Heater 3000
/ 2000 Watts for 2 sizes resp.
Control Less than 50 Watts
Operating
Voltage 230 Volts +/- 10%, 50 Hz,
1Phase
Controller
Type Micro Computerized with
LCD Display
Display Type
4 x 20 Liquid Crystal
Display (4 rows x 20 characters)
No. of flasks accommodated
About 16 / 8 for 2 sizes resp.
Protection Password
Protection against un-authorized tampering
Power Failure
Memory Built-in
Curing Process
2 Time – Temp cycles with Auto Changeover:
Default
Cycle 65deg. C for 45
mins; 95 Deg.C for 60 mins
Set Temperature / Time By
various keys on keyboard.
Temp / Time Set Range 0 to
99 Deg C. / 0 to 9:59 (H:MM)
User
Cycles Programmable
through front panel key switches
Alert / Message
Indication Blinking Light with message on
screen
Screen
Display 1) Help Messages, 2)
Error Messages, 3) Set and Actual
Temp, 4) Set and Balance Time, 5) Pre Cure / Curing
Cycle
Running, 6) Temp Rise / Fall, 7) Temp Bar Graph,
8) Process Over
Message 9) Heater Status
Process
End Auto OFF with
Message and Alerts
POWER
FAILURE MEMORY – HOW IT WORKS?
Once the
“Run” key is pressed, the process starts and
micro-controller continuously monitors the process
parameters and saves them in internal memory. At Power
Failure these process parameters are stored in Memory
provided on board. This memory is non-volatile and can
be retained for a long period.
On
resumption of power, the controller restarts and
retrieves the temperature value at power failure and
compares it with actual value on power resumption. If
the drop in temperature is more than 10% of the value at
power failure, then the processor re-starts the process
from beginning and if f the drop in temperature is less
than 10% of the stored value, then the process resumes
from where it stopped at power failure.
This is
done automatically.
WHY PASSWORD?
Password
is required only to edit process parameters like set
temperature time. Password is not required to Run the
Process with previously set values.
This
facilitates the control of Supervisor or H.O.D over
process parameters set values and permits the Junior
staff / student to run the process without need of
presence to Supervisor / H. O. D.
WHAT IF
PASSWORD FORGOTEN?
If the user has forgotten
Password, then the default Password can be loaded
through Key Switch on the right face of the control
panel.
DESIGN & SPECS SUBJECT TO CHANGE WITHOUT NOTICE | 