PRODUCTS>Auto Clave - Front Loading                 

FEATURES:

Micro computerised control with LCD screen for messages and

                                                                With Unique

Power failure memory : auto re-starts process on power resumption.

User friendly:

        single key press starts & completes process on its own * supervision not required * displays “process over” message on completion * blinking light for user attention on message on screen * help messages on screen * Automatic release of steam on completion of wet cycle

Password Protection: Protects tampering of set parameters:

User programmable : Temp: 121 to 130 deg. C, Time: 15 to 59 mins, Cycle: Wet or Wet and Dry

Ease of Operation: Front Loading

Robust construction: stainless steel claving chamber with M. S. Powder Coated body

Safety: process power configured in cut-off mde in its steady state of rest

Versatility: permits stop & edit at any time during process run.

Option for Dry Cycle.

Self Diagnostic Software: Identifies process faults and displays on LCD screen

Specifications:

Power Rating – Heater       1000 Watts

Drum Size                             10"(D) x 10" (L)

Control System                    Less than 50 Watts

Water Filling                         Manual

Operating Voltage               230 Volts +/- 10%, 50 Hz, 1Phase

Control Type                         Micro-computerised control with LCD display.

Protection                             Password Protection against un-authorized tampering

Memory                                 Saves Process condition at power failure and continues on Power

                                               Resumption.

Alerts Indication                   By Blinking Light.

Temp Set Range                 121 to 130 Degree Centigrade

Set Time Range                  15 to 59 Minutes

Cycles                                   User programmable - only wet cycle or wet and dry cycles

Display                                 2 x 16 Liquid Crystal Display  (2 Rows x 16 Characters)

Indication on Display          Set/Actual Temp in Deg. Centigrade *  Set Time in MM*

                                              Process Alerts *  Process Over

 POWER FAILURE MEMORY – HOW IT WORKS?

 Once the “Run” key is pressed, the process starts and micro-controller  continuously monitors the process parameters and saves them in internal memory.  At Power Failure these process parameters are stored in Memory provided on board. This memory is non-volatile and can be retained for a long period.

 On resumption of power, the controller restarts and retrieves the temperature value at power failure and compares it with actual value on power resumption.  If the drop in temperature is more than 10% of the value at power failure, then the processor re-starts the process from beginning and if f the drop in temperature is less than 10% of the stored value, then the process resumes from where it stopped at power failure.

 This is done automatically.

 WHY PASSWORD?

 Password is required only to edit process parameters like set temperature time. Password is not required to Run the Process with previously set values.

 This facilitates the control of Supervisor or H.O.D over process parameters set values and permits the Junior staff / student to run the process without need of presence to Supervisor / H. O. D.

 WHAT IF PASSWORD FORGOTEN?

 If the user has forgotten Password, then the default Password can be loaded through Key Switch on the right face of the control panel.

 DESIGN & SPECS SUBJECT TO CHANGE WITHOUT NOTICE