|
PRODUCTS>Cast Duplicator 
FEATURES:
Capacity:
3 kg
– ideal for the day’s work
Micro computerized control with Large LCD screen for messages & values and
With
Unique
Power Failure Memory: auto
re-start on resumption of power
User friendly :
single key press starts & completes
process on its own *
supervision not required
* displays “process over“ message on completion *
blinking light
draws user attention for message on
screen * flashes
help messages on screen
to guide user
User programmable -
temperature and time
Stirrer on/off facilitated by front panel key switch
Prepares & maintains duplicating gel in ready to use
form for indefinite period.
Low power uniform heating from all sides prevents
burning of gel
Low speed stirrer ensures homogenous mixing without
splashing
Convenient outlet for ease of dispensing
Ultra
low power continuous heating of outlet ensures gel does
not solidify in outlet system
Password Protected:
Prevents tampering of set parameters
Robust unit:
fully stainless steel
body.
Safety: power configured in
cut-off
mode in its natural steady state of rest
Versatility: permits
stop & edit
at any time during process
on
Self Diagnostic Software: Identifies and displays on
screen fault occurred during process run.
Specifications:
Construction
Stainless Steel
Gel
Filling Small pieces
of Gel filled Manually
Capacity 3 Kg
Power Rating –
Heater 250 Watts
Control Less than 50 Watts
Operating
Voltage 230 Volts +/- 10%, 50 Hz,
1Phase
Controller
Type Micro Computeised with
LCD Display
Display Type
2 x 16 Liquid Crystal
Display (2 rows x 16 characters)
Protection
Password Protection against un-authorized tampering
Power Failure
Memory Built-in
Process
2 Time – Temp cycles with Auto Changeover:
Default
Settings 92deg. C for 5 mins;
55 Deg.C indefinitely
Set Temperature /
Time By various keys on keyboard.
Temp / Time Set
Range 0 to 100 Deg C. / 0 to 9:59 (H:MM)
User
Cycles Programmable
through front panel key switches
Alert / Message
Indication Blinking Light with display on
screen
Screen
Display 1) Help Messages
2) Error Messages 3) Set & Actual Temp
4) Set and Balance Time, 5) Cycle Running, 6) Process
Over
POWER
FAILURE MEMORY – HOW IT WORKS?
Once the
“Run” key is pressed, the process starts and
micro-controller continuously monitors the process
parameters and saves them in internal memory. At Power
Failure these process parameters are stored in Memory
provided on board. This memory is non-volatile and can
be retained for a long period.
On
resumption of power, the controller restarts and
retrieves the temperature value at power failure and
compares it with actual value on power resumption. If
the drop in temperature is more than 10% of the value at
power failure, then the processor re-starts the process
from beginning and if f the drop in temperature is less
than 10% of the stored value, then the process resumes
from where it stopped at power failure.
This is
done automatically.
WHY PASSWORD?
Password
is required only to edit process parameters like set
temperature time. Password is not required to Run the
Process with previously set values.
This
facilitates the control of Supervisor or H.O.D over
process parameters set values and permits the Junior
staff / student to run the process without need of
presence to Supervisor / H. O. D.
WHAT IF
PASSWORD FORGOTEN?
If the user has forgotten
Password, then the default Password can be loaded
through Key Switch on the right face of the control
panel.
DESIGN
& SPECS SUBJECT TO CHANGE WITHOUT NOTICE
| 